Building Standards: Uniform Building Code1985 - Building laws |
From inside the book
Results 1-3 of 87
Page 33
... conform to this grade . Compliance with this grade is also recommended where a high and uniform degree of resistance to disintegration by weathering is desired . Grade MW . Brick intended for use where exposed to temperatures below ...
... conform to this grade . Compliance with this grade is also recommended where a high and uniform degree of resistance to disintegration by weathering is desired . Grade MW . Brick intended for use where exposed to temperatures below ...
Page 607
... conform to U.B.C. Standard No. 26-1 . Where the requirements are in conflict with this standard , the requirements of the Uniform Building Code shall govern . For the purpose of these specifications , ready - mixed concrete is portland ...
... conform to U.B.C. Standard No. 26-1 . Where the requirements are in conflict with this standard , the requirements of the Uniform Building Code shall govern . For the purpose of these specifications , ready - mixed concrete is portland ...
Page 638
... conform to the requirements of one of the listed specifica- tions , test specimens and procedure shall conform to approved standards . In the case of material , the mechanical properties of which do not conform to the requirements of ...
... conform to the requirements of one of the listed specifica- tions , test specimens and procedure shall conform to approved standards . In the case of material , the mechanical properties of which do not conform to the requirements of ...
Contents
CHAPTER | 7 |
Standard and Subject 1256 October 1979 of the Underwriters Laboratories | 14 |
CHAPTER | 26 |
Copyright | |
11 other sections not shown
Other editions - View all
Common terms and phrases
accordance adhesive allowable load apply average beams bending members Black knots bolt bonding BUILDING CODE STANDARD butt joints combinations compression compression members connector core cross section design value determined diameter dimensions Douglas fir E-rated eastern white pine edge end joints exceed FACE WIDTH feet fiber flange glue lines glued hem-fir holes inch wide Inner knots lag screw laminating grade lams length less limiting provisions localized cross grain lumber manufactured masonry material maximum measured medium grain minimum modulus of elasticity moisture content nails nominal outer tension panel parallel percent permitted perpendicular plies plywood pounds per square procedures requirements sample sapwood scarf joints seasoning checks shake shear shear strength slope of grain southern pine spaced specified splits square inch strength stress structural surface Table temperature tension laminations Tension Zone test specimens thermocouples timber U.B.C. Standard Uniform Building Code veneer visually graded wane wide face wood failure