Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volumes 3-5American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 81
Page 444
... depth for the joint under the brace axial tension ( AKA1 ) are presented in Figure 9a . There are two contradicting factors to control the magnitude of the stress intensity factor as the crack grows deeper with fixed crack length . The ...
... depth for the joint under the brace axial tension ( AKA1 ) are presented in Figure 9a . There are two contradicting factors to control the magnitude of the stress intensity factor as the crack grows deeper with fixed crack length . The ...
Page 108
... depth than in 30 m depth . Increasing water depth will of course reduce the wave induced fatigue damage significantly , due to reduced wave loading intensity . Limiting Failure Mode By comparing data from the numerical study by Sotberg ...
... depth than in 30 m depth . Increasing water depth will of course reduce the wave induced fatigue damage significantly , due to reduced wave loading intensity . Limiting Failure Mode By comparing data from the numerical study by Sotberg ...
Page 183
... depth is uniformly 5 mm ( 0.197 in ) . The pipe is subjected to an internal pressure of 12 MPa ( 1740 psi ) , an axial tension load of 2.5 MN ( 116000 lb ) in addition to what is induced by the pressure load ( the pipe ends are closed ) ...
... depth is uniformly 5 mm ( 0.197 in ) . The pipe is subjected to an internal pressure of 12 MPa ( 1740 psi ) , an axial tension load of 2.5 MN ( 116000 lb ) in addition to what is induced by the pressure load ( the pipe ends are closed ) ...
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
Measurement and Prediction of Welding Residual Stresses Using | 7 |
Prediction of Residual Stresses and Distortions in Welded Structures | 25 |
Copyright | |
56 other sections not shown
Other editions - View all
Common terms and phrases
aluminium amplitude analysis as-welded austenite axial bending calculated CGHAZ Charpy chemical composition coating components cooling corrosion crack front crack tip CTOD CTOD fracture toughness CTOD test CTOD value curves developed diameter distribution evaluation experimental factor fatigue crack fatigue strength ferrite Figure fracture mechanics fracture toughness gauges geometry Grade grain groove Gullfaks heat input ICCGHAZ increase kJ/mm living quarter load martensite Materials Engineering ASME measured mechanical properties method microstructure multi-pass narrow gap offshore structures OMAE parameters pearlite pipe plate thickness Pop-in prediction pressure PWHT residual stress riser S-N curves seawater shown simulation slot Statoil steel plate strain gauges stress concentration stress range surface notched Table tapered joint temperature tensile thickness effect titanium alloys TMCP tubular underwater welding weld metal weld toe welded joints Welding Institute welding procedure welding process welding residual stress weldments wire yield strength zone