Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volumes 3-5American Society of Mechanical Engineers, 1991 - Arctic regions |
From inside the book
Results 1-3 of 81
Page 103
Strain measurements along the panels obtained from strain gages located at the back and front ( cracked side ) surfaces are shown in Figures 7 and 8 for 1.0 and 3.0 mm of total elongations . It is apparent that the considerable strain ...
Strain measurements along the panels obtained from strain gages located at the back and front ( cracked side ) surfaces are shown in Figures 7 and 8 for 1.0 and 3.0 mm of total elongations . It is apparent that the considerable strain ...
Page 188
The cutting sheet of ice crystal is shown in Fig . 2. It is obviously from this figure that the cutting sheet along the direction perpendicular to the surface of ice slab is columnar ice , this is identical not only with the crystalline ...
The cutting sheet of ice crystal is shown in Fig . 2. It is obviously from this figure that the cutting sheet along the direction perpendicular to the surface of ice slab is columnar ice , this is identical not only with the crystalline ...
Page 194
It will be shown that this type of combined bending and tension is less severe than that encountered in the cases discussed above . The response of long , elastic tubes under combined bending and tension was examined by Fabian ( 1977 ) ...
It will be shown that this type of combined bending and tension is less severe than that encountered in the cases discussed above . The response of long , elastic tubes under combined bending and tension was examined by Fabian ( 1977 ) ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
RESIDUAL STRESS AND DISTORTION IN WELDS | 1 |
Measurement and Prediction of Welding Residual Stresses Using | 7 |
WELD METAL AND HAZ PROPERTIES | 37 |
Copyright | |
48 other sections not shown
Other editions - View all
Common terms and phrases
alloys aluminium analysis application axial base bending calculated CGHAZ coating compared components composition connection considered constant cooling corrosion cost crack critical CTOD curves cycle depth developed distribution effect element energy Engineering evaluation experimental experiments factor fatigue field Figure fracture geometry given Grade grain hardness heat higher improved increase indicated initiation length living load lower material measured mechanical metal method microstructure notched observed obtained offshore operation parameters pass performed pipe plate position possible prediction present pressure procedure production properties range reduced region residual stress resistance root seawater shown shows simulation specimens steel strain strength structure surface Table technique temperature tensile thermal thickness Titanium toughness values weld metal welded joints wire yield zone