## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 4; Volume 8, Part 4American Society of Mechanical Engineers, 1989 - Arctic regions |

### From inside the book

Results 1-3 of 85

Page 165

10.000 4,000,000 2,000,000 FIG . 6 PROBABILITY OF SUCCESSFUL

DEFLECTION AS A FUNCTION OF ICEBERG

function of iceberg

water surface ...

10.000 4,000,000 2,000,000 FIG . 6 PROBABILITY OF SUCCESSFUL

DEFLECTION AS A FUNCTION OF ICEBERG

**MASS**The probability densityfunction of iceberg

**mass**: a set of 104 areal measurements of iceberg area at thewater surface ...

Page 312

Thus for the purpose of this paper we shall assume a value of e = 0.40 for low

speed which combines the elastic and plastic effects of the deformation . curve

Equation 5 gives the total impulse ( area under the full in Figure 3 ) in terms of

Thus for the purpose of this paper we shall assume a value of e = 0.40 for low

speed which combines the elastic and plastic effects of the deformation . curve

Equation 5 gives the total impulse ( area under the full in Figure 3 ) in terms of

**mass**...Page 430

If the meteorological parameters are assumed constant a very simple relation

between icing

function of time :

Mo is ...

If the meteorological parameters are assumed constant a very simple relation

between icing

**mass**and time is obtained . The increasing ice**mass**is a linearfunction of time :

**MASS**OF ... ICE..ok 9 % cm3 M ( t ) = Mo + Kt ( 3 ) 9.00 whereMo is ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

OFFSHORE MECHANICS | 1 |

ICE FORCES | 11 |

MATERIALS TECHNOLOGY | 24 |

Copyright | |

22 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applied approach Arctic assumed average behaviour body calculated coefficient components compression compressive stress computed considered constant crack creep damage deformation dependent depth described determined developed diameter direction distribution effect elastic energy Engineering equation estimate experiments expression factor failure field Figure floe force fracture frequency function given grain grain boundary horizontal ice sheet iceberg impact increase initial International length limit load mass material maximum mean measured Mechanics method microcracks motion normal nucleation observed obtained Offshore operation parameters peak performed plane position predicted present pressure probability range ratio Regions relation relative Research resistance ridge samples sea ice shear ship shown shows simulation specimen strain rate strength stress structure surface Table temperature tensile tensor tests thickness toughness uniaxial vertical wave