## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 4; Volume 8, Part 4American Society of Mechanical Engineers, 1989 - Arctic regions |

### From inside the book

Results 1-3 of 61

Page 52

0.10

curves for the multiaxial creep damage and rate - sensitive cracking model under

tension in the direction of the coordinate z . Figure 6. Stress - strain curves for the

...

0.10

**STRAIN RATE**LOG 0.10 -4.0**STRAIN RATE**LOG Figure 5. Stress - straincurves for the multiaxial creep damage and rate - sensitive cracking model under

tension in the direction of the coordinate z . Figure 6. Stress - strain curves for the

...

Page 68

Maximum peak stresses were found by Hawkes and Mellor ( 1972 ) to occur at

Cole ( 1985 ) , while Jones ( 1982 ) reported maximum peak stresses

of ...

Maximum peak stresses were found by Hawkes and Mellor ( 1972 ) to occur at

**strain rates**of between 10-3 s - 1 and 2x10-3 so . The same result was found byCole ( 1985 ) , while Jones ( 1982 ) reported maximum peak stresses

**strain rate**of ...

Page 80

Mellor and Cole ( 1982 ] have observed that the applied stress and minimum

constant applied

correspondence ...

Mellor and Cole ( 1982 ] have observed that the applied stress and minimum

**strain**-**rate**for a creep test correspond respectively to the maximum stress andconstant applied

**strain**-**rate**for a strength test . They discussed thecorrespondence ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

OFFSHORE MECHANICS | 1 |

ICE FORCES | 11 |

MATERIALS TECHNOLOGY | 24 |

Copyright | |

22 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applied approach Arctic assumed average behaviour body calculated coefficient components compression compressive stress computed considered constant crack creep damage deformation dependent depth described determined developed diameter direction distribution effect elastic energy Engineering equation estimate experiments expression factor failure field Figure floe force fracture frequency function given grain grain boundary horizontal ice sheet iceberg impact increase initial International length limit load mass material maximum mean measured Mechanics method microcracks motion normal nucleation observed obtained Offshore operation parameters peak performed plane position predicted present pressure probability range ratio Regions relation relative Research resistance ridge samples sea ice shear ship shown shows simulation specimen strain rate strength stress structure surface Table temperature tensile tensor tests thickness toughness uniaxial vertical wave