## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 91

Page 194

+ a3 + b3 a4b3 + a3b2 Pi + P2 Pa ( 9.3 : 17 ) a3 + b3 Therefore a compressive

end plates of Fig . 9.11 . If the constraint w = 0 is dropped and an additional

external ...

+ a3 + b3 a4b3 + a3b2 Pi + P2 Pa ( 9.3 : 17 ) a3 + b3 Therefore a compressive

**axial**force of F – ( P1 + P2 ) is required to prevent relative**axial**motion w of theend plates of Fig . 9.11 . If the constraint w = 0 is dropped and an additional

external ...

Page 208

The total stress is always just the sum of the stresses which would be caused by

each load acting alone and so is determined by the loads without reference to the

properties of the material other than the homogeneity associated with

The total stress is always just the sum of the stresses which would be caused by

each load acting alone and so is determined by the loads without reference to the

properties of the material other than the homogeneity associated with

**axial**...Page 210

4 / YIELD CURVES AND SURFACES ( IN STRESS SPACE ) Suppose now that a

number of closed - end thin - walled circular tubes of a particular structural metal

are tested under various combinations of

4 / YIELD CURVES AND SURFACES ( IN STRESS SPACE ) Suppose now that a

number of closed - end thin - walled circular tubes of a particular structural metal

are tested under various combinations of

**axial**force R , interior pressure p , and ...### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

actual addition angle answer applied assemblage axes axial axis beam behavior bending circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve cylinder deflection deformation determined diameter direction displacement effect elastic equal equation equilibrium example Figure Find force given gives homogeneous idealization increase initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires residual response result rotation shaft shear stress shell shown shows simple sketch solid solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled torsion tube twisting uniform unloading versus viscous yield zero