## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 68

Page 92

Calculations offer little difficulty beyond that of geometry . If the bars are both

linear - elastic , the history of the loading has no influence on their deformation .

The elongation of each is

both ...

Calculations offer little difficulty beyond that of geometry . If the bars are both

linear - elastic , the history of the loading has no influence on their deformation .

The elongation of each is

**determined**by the present value of the force . If one orboth ...

Page 208

The total stress is always just the sum of the stresses which would be caused by

each load acting alone and so is

properties of the material other than the homogeneity associated with axial ...

The total stress is always just the sum of the stresses which would be caused by

each load acting alone and so is

**determined**by the loads without reference to theproperties of the material other than the homogeneity associated with axial ...

Page 228

Two points are sufficient to

the on axis . ... The pole is

inclination a of the 10 , 000 - psi normal stress on plane 1 , or by the line through

3 ...

Two points are sufficient to

**determine**the circle , because its center must lie onthe on axis . ... The pole is

**determined**by the line through point 1 at the angle ofinclination a of the 10 , 000 - psi normal stress on plane 1 , or by the line through

3 ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

actual addition angle answer applied assemblage axial axis beam behavior bending circle circular column combined components compression compressive stress computed Consider constant creep cross section curve cylinder deflection deformation determined diameter direction displacement effect elastic equal equation equilibrium example Figure Find force given gives homogeneous idealization increase initial interior isotropic length limit linear linear-elastic load material maximum Maxwell modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced pure radius range ratio relation replaced requires residual response result rotation shaft shear stress shell shown shows simple sketch solid solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled torsion tube twisting uniform unloading viscous yield zero