## Introduction to Mechanics of Deformable Solids |

### From inside the book

Results 1-3 of 58

Page 156

34 A rectangular bar of steel , 1 in . wide , 4 in . high , and 3 ft long , is heated

uniformly on its top

The temperature induced in the bar is 164°F everywhere at the top

100°F ...

34 A rectangular bar of steel , 1 in . wide , 4 in . high , and 3 ft long , is heated

uniformly on its top

**surface**and insulated completely on its two side**surfaces**.The temperature induced in the bar is 164°F everywhere at the top

**surface**and100°F ...

Page 258

Normally they much prefer the tedious direct approach to the answer over the

interesting short cuts which require estimation or " judgment ” by comparison of

two numbers or more . 11 . 8 / PROBLEMS OF STRAIN IN A

Three ...

Normally they much prefer the tedious direct approach to the answer over the

interesting short cuts which require estimation or " judgment ” by comparison of

two numbers or more . 11 . 8 / PROBLEMS OF STRAIN IN A

**SURFACE**11 . 16Three ...

Page 282

of the space without altering the ellipsoidal nature of the

- line segment joining two points of the curve or

else ; tangent planes or lines are everywhere outside the

of the space without altering the ellipsoidal nature of the

**surfaces**. ... Any straight- line segment joining two points of the curve or

**surface**lies inside everywhereelse ; tangent planes or lines are everywhere outside the

**surface**except at the ...### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

acts actual addition angle answer applied assemblage axes axial axis beam behavior bending carry circle circular column combined compatibility components compression compressive stress Consider constant creep cross section curve deflection deformation determined diameter dimensions direction displacement effect elastic equal equation equilibrium example Find force given gives homogeneous idealization increase initial interior isotropic length limit linear linear-elastic load material maximum Maxwell MICHIGAN modulus moment needed nonlinear normal obtained outer plane plastic positive pressure principal Prob problem produced radius range ratio replaced requires response result rotation shear stress shell shown shows simple sketch solution steel strain stress-strain relations structural Suppose surface symmetry temperature tensile tension thickness thin-walled tube twisting uniform unloading viscous yield zero