## Mechanical metallurgy |

### From inside the book

Results 1-3 of 87

Page 60

Cn — ^ Lame's constant Cu = 2G + \ (2-99) Cm = i(Qi Q2) The technical elastic

moduli E, v, and G are usually

tension or torsion tests. However, where more precise

required or ...

Cn — ^ Lame's constant Cu = 2G + \ (2-99) Cm = i(Qi Q2) The technical elastic

moduli E, v, and G are usually

**measured**by direct static**measurements**in thetension or torsion tests. However, where more precise

**measurements**arerequired or ...

Page 364

The COD, denoted by A, is

provides an indirect way to

center of a crack of length 2a, then COD = A = y[(a + r/,)2-x2]1/2 (11-34) where x

is the ...

The COD, denoted by A, is

**measured**with a clip gage.**Measurement**of Aprovides an indirect way to

**measure**6. If the origin of**measurement**is at thecenter of a crack of length 2a, then COD = A = y[(a + r/,)2-x2]1/2 (11-34) where x

is the ...

Page 559

Residual stresses are difficult to calculate with precision by analytical methods,1

and therefore, they are usually determined by a variety of experimental

techniques.2 Most methods of

because they ...

Residual stresses are difficult to calculate with precision by analytical methods,1

and therefore, they are usually determined by a variety of experimental

techniques.2 Most methods of

**measuring**residual stresses are destructivebecause they ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

Stress and Strain Relationships for Elastic Behavior | 18 |

from Elastic Strains 213 Strain Energy 214 Anisotropy | 46 |

Metallurgical Fundamentals | 101 |

Copyright | |

15 other sections not shown

### Other editions - View all

### Common terms and phrases

alloy angle annealed ASTM atoms axis behavior billet brittle fracture Burgers vector cold-worked components compression constant crack creep cycles decrease determined diameter direction dislocation line ductile edge dislocation elastic elongation embrittlement energy engineering equation extrusion factor failure fatigue limit fiber Figure flow curve flow stress force forging friction given grain boundaries hot-working hydrostatic increase indentation lattice length load machining martensite material matrix maximum measured mechanical metallurgical Metals Park modulus necking notch occurs particles percent plane strain plane-strain plastic deformation plastic strain pressure produce properties ratio recrystallization reduction region residual stresses rolling screw dislocation shear stress sheet shown in Fig slip plane slip systems Society for Metals specimen steel strain hardening strain rate stress-strain curve structure surface temperature tensile strength tensile stress tension test tensor thickness tool torsion Trans usually velocity workpiece yield strength yield stress