Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 85
Page i
PROCEEDINGS OF THE 15TH INTERNATIONAL CONFERENCE ON OMAE 199 6 OFFSHORE MECHANICS AND ARCTIC ENGINEERING VOLUME III MATERIALS ENGINEERING SPONSORED BY The American Society of Mechanical Engineers ( ASME ) , USA OMC s.c.r.1 . , Italy ...
PROCEEDINGS OF THE 15TH INTERNATIONAL CONFERENCE ON OMAE 199 6 OFFSHORE MECHANICS AND ARCTIC ENGINEERING VOLUME III MATERIALS ENGINEERING SPONSORED BY The American Society of Mechanical Engineers ( ASME ) , USA OMC s.c.r.1 . , Italy ...
Page 443
... Engineering , UMIST , November 1987 . [ 15 ] Cheatani , M. J. , Ultimate Failure of Tubular Connections , Final Report , Project DA709 ( Phase II ) , Department of Civil and Structural Engineering , UMIST , December 1991 . [ 16 ] Hyde ...
... Engineering , UMIST , November 1987 . [ 15 ] Cheatani , M. J. , Ultimate Failure of Tubular Connections , Final Report , Project DA709 ( Phase II ) , Department of Civil and Structural Engineering , UMIST , December 1991 . [ 16 ] Hyde ...
Page 529
... Engineering Conference , 1991 . Forbes , J. , Glinka , G and Burns , D.J. ' Fracture mechanics analysis of fatigue cracks and load shedding in tubular welded joints ' , 11th Int . Conf . on Offshore Mechanics and Arctic Engineering ...
... Engineering Conference , 1991 . Forbes , J. , Glinka , G and Burns , D.J. ' Fracture mechanics analysis of fatigue cracks and load shedding in tubular welded joints ' , 11th Int . Conf . on Offshore Mechanics and Arctic Engineering ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength