Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 77
Page 23
... containing a flaw in the brace , lower bound collapse loads should be calculated separately for axial loading , in - plane bending and out - of - plane bending for the overall cross - section of the member containing the flaw , based on ...
... containing a flaw in the brace , lower bound collapse loads should be calculated separately for axial loading , in - plane bending and out - of - plane bending for the overall cross - section of the member containing the flaw , based on ...
Page 47
... containing < 0.003 % A1 and 0.05 % Ti is shown in Fig.13 . The influence on the microstructure of combined additions of Al and Ti is best considered in two groups . In welds containing < 0.01 % Al , Ti additions markedly reduced the ...
... containing < 0.003 % A1 and 0.05 % Ti is shown in Fig.13 . The influence on the microstructure of combined additions of Al and Ti is best considered in two groups . In welds containing < 0.01 % Al , Ti additions markedly reduced the ...
Page 383
... containing overmatched repair weld joints . The deformation and fracture characteristics of the repair welded wideplates notched at the original weld deposit , repair weld and HAZ regions are discussed . The aim of this work was to ...
... containing overmatched repair weld joints . The deformation and fracture characteristics of the repair welded wideplates notched at the original weld deposit , repair weld and HAZ regions are discussed . The aim of this work was to ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength