Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 17
... determined by integrating thus : af N = ( 14 ) m · 7.6≤ y ≤32.0 · 0.2 ≤T≤1.0 • 35 ° ≤0≤90 ° The relatively low upper limit on a was not considered to be a major limitation since it was found that the effect of a is not ...
... determined by integrating thus : af N = ( 14 ) m · 7.6≤ y ≤32.0 · 0.2 ≤T≤1.0 • 35 ° ≤0≤90 ° The relatively low upper limit on a was not considered to be a major limitation since it was found that the effect of a is not ...
Page 25
... determined . This is the basis on which reliability analysis is used to determine inspection intervals . The target reliability is determined by the redundancy and accessibility of the structural component . Procedure The following ...
... determined . This is the basis on which reliability analysis is used to determine inspection intervals . The target reliability is determined by the redundancy and accessibility of the structural component . Procedure The following ...
Page 226
... determined by using the following strategy : firstly , based upon the ultimate load capacity of uniplanar joints , the multiplanar geometrical stiffening effects are determined for multiplanar joints with JAA = 0 ; secondly , based on ...
... determined by using the following strategy : firstly , based upon the ultimate load capacity of uniplanar joints , the multiplanar geometrical stiffening effects are determined for multiplanar joints with JAA = 0 ; secondly , based on ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength