Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 85
Page 349
... crack growth constants and a fracture mechanics model . Good correlation was obtained between the experimental endurance data in both air and seawater environments and fracture mechanics predictions . The results also gave an insight ...
... crack growth constants and a fracture mechanics model . Good correlation was obtained between the experimental endurance data in both air and seawater environments and fracture mechanics predictions . The results also gave an insight ...
Page 353
... fracture mechanics analysis . As a consequence care should be taken when applying the results of fracture mechanics analyses to cracked tubular joints dis- covered in service . DISCUSSION The primary aim of the study was to demonstrate ...
... fracture mechanics analysis . As a consequence care should be taken when applying the results of fracture mechanics analyses to cracked tubular joints dis- covered in service . DISCUSSION The primary aim of the study was to demonstrate ...
Page 529
... fracture mechanics approach of fatigue of welded joints in offshore structures ' , Offshore Mechanics and Arctic Engineering Conference , 1993 . Dover , W. D. and Dharmavasan , S. ' Fatigue fracture mechanics analysis of T and Y joints ...
... fracture mechanics approach of fatigue of welded joints in offshore structures ' , Offshore Mechanics and Arctic Engineering Conference , 1993 . Dover , W. D. and Dharmavasan , S. ' Fatigue fracture mechanics analysis of T and Y joints ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength