Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 49
Page 418
... strength steel grades has been the subject of much discussion by the offshore industry . There is limited information on the long - term performance of these materials under the severe ... HIGH STRENGTH STEELS IN JACK - UPS The 418.
... strength steel grades has been the subject of much discussion by the offshore industry . There is limited information on the long - term performance of these materials under the severe ... HIGH STRENGTH STEELS IN JACK - UPS The 418.
Page 426
... High strength steels tested at Cranfield University [ 27 ] The results from the steels tested generally indicate that the fatigue crack growth rate performance of parent and welded high strength steels in the range 400 - 600 MPa is ...
... High strength steels tested at Cranfield University [ 27 ] The results from the steels tested generally indicate that the fatigue crack growth rate performance of parent and welded high strength steels in the range 400 - 600 MPa is ...
Page 427
... steel grades ( 355EMZ , 450EMZ and 701RQT ) to evaluate the performance of high strength tubular joints . DISCUSSION The information presented above indicates that several different types of high strength steels are in use offshore ...
... steel grades ( 355EMZ , 450EMZ and 701RQT ) to evaluate the performance of high strength tubular joints . DISCUSSION The information presented above indicates that several different types of high strength steels are in use offshore ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses ring riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength