Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 86
Page 251
... indicate the reductions in member strength that can result from such non - detections , and that not all damage is likely to be found immediately after an event . As noted earlier push - over analyses are being increasingly used in ...
... indicate the reductions in member strength that can result from such non - detections , and that not all damage is likely to be found immediately after an event . As noted earlier push - over analyses are being increasingly used in ...
Page 427
... indicate that the toughness properties of welded material can be rather variable , with both high and low toughness values having been measured in welded material . The low results are not necessarily restricted to the higher end of the ...
... indicate that the toughness properties of welded material can be rather variable , with both high and low toughness values having been measured in welded material . The low results are not necessarily restricted to the higher end of the ...
Page 440
... indicate that the strength ratio is sensitive to the choice of static strength equation used to normalise the experimental data . For joints under balanced axial and axial tension loading , the use of the HSE compression strength gives ...
... indicate that the strength ratio is sensitive to the choice of static strength equation used to normalise the experimental data . For joints under balanced axial and axial tension loading , the use of the HSE compression strength gives ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses ring riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength