Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 65
Page 417
... Limited Cranleigh , Horsham Surrey , UK International Conference on Offshore Mechanics and Arctic Engineering , Florence. 1996 OMAE - Volume III , Materials Engineering ASME 1996 ABSTRACT High strength steels , defined as steels with ...
... Limited Cranleigh , Horsham Surrey , UK International Conference on Offshore Mechanics and Arctic Engineering , Florence. 1996 OMAE - Volume III , Materials Engineering ASME 1996 ABSTRACT High strength steels , defined as steels with ...
Page 427
... limited . This is a consequence of the limited amount of available test data to support guidance and codes for high strength steels , both for the fatigue and static strength assessment of components , although continuing research is ...
... limited . This is a consequence of the limited amount of available test data to support guidance and codes for high strength steels , both for the fatigue and static strength assessment of components , although continuing research is ...
Page 442
... limited to the range 0.40 -0.67 and further work is required to confirm the y effect at higher ẞ ratios . the limited data imply that the static strength reduction of cracked joints is greater at high ẞ ratios and this work is currently ...
... limited to the range 0.40 -0.67 and further work is required to confirm the y effect at higher ẞ ratios . the limited data imply that the static strength reduction of cracked joints is greater at high ẞ ratios and this work is currently ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses ring riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength