Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 85
Page 276
... material that is inherently corrosion resistant to seawater and the marine environment does not require an external corrosion protection system or corrosion allowances on wall thickness . Resistance to Well Fluids : More fields are ...
... material that is inherently corrosion resistant to seawater and the marine environment does not require an external corrosion protection system or corrosion allowances on wall thickness . Resistance to Well Fluids : More fields are ...
Page 365
... materials . In the under - matched bi - material specimens , the ratio of the width of low strength region including a notch to the thickness ( H / t ) are 1/4 and 1/2 . And specimens with shallow notch ( a / W = 0.15 ) are tested as ...
... materials . In the under - matched bi - material specimens , the ratio of the width of low strength region including a notch to the thickness ( H / t ) are 1/4 and 1/2 . And specimens with shallow notch ( a / W = 0.15 ) are tested as ...
Page 506
made from material in the T4 condition . The large scale tests on sections of the bridge deck was made on 6005 material in the T6 condition only . The chemical composition and mechanical properties are listed in Tables 1 and 2 . Table 1 ...
made from material in the T4 condition . The large scale tests on sections of the bridge deck was made on 6005 material in the T6 condition only . The chemical composition and mechanical properties are listed in Tables 1 and 2 . Table 1 ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength