Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 80
Page 94
... measured . The fluctuation of instantaneous pressure and flow speeds at each points are other important indices , but they had not measured in this experiment . The purpose of this experiment is to consider the effects of swirl flow and ...
... measured . The fluctuation of instantaneous pressure and flow speeds at each points are other important indices , but they had not measured in this experiment . The purpose of this experiment is to consider the effects of swirl flow and ...
Page 357
... Measured length ( 2c ) 225 200 175 150 Depth ( a ) mn 5 10 . 20 20 Predicted depth ( R = 0.3 ) Measured depth ( ACFM ) 15 125 0 . 0E + 00 2E + 05 5E + 05 8E + 05 1E + 06 OE + 00 2E + 05 4E + 05 6E + 05 8E + 05 Cycles ( N ) Cycles ( N ) ...
... Measured length ( 2c ) 225 200 175 150 Depth ( a ) mn 5 10 . 20 20 Predicted depth ( R = 0.3 ) Measured depth ( ACFM ) 15 125 0 . 0E + 00 2E + 05 5E + 05 8E + 05 1E + 06 OE + 00 2E + 05 4E + 05 6E + 05 8E + 05 Cycles ( N ) Cycles ( N ) ...
Page 413
... measured when the amount of cold - rolling was smaller than 20 % . After that , the martensite content increased with increasing amount of cold- rolling until it peaked at a level of about 2,5 % when amount of cold - rolling was 40 ...
... measured when the amount of cold - rolling was smaller than 20 % . After that , the martensite content increased with increasing amount of cold- rolling until it peaked at a level of about 2,5 % when amount of cold - rolling was 40 ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength