Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 33
Page 487
... stiffening rings . i . External surface cracking . From the results obtained in this and other projects ( Munaswamy et al , 1989 ; Holmes et al , 1987 and 1988 ; Brandi , 1981 ) it is clear that external surface crack initiation in ...
... stiffening rings . i . External surface cracking . From the results obtained in this and other projects ( Munaswamy et al , 1989 ; Holmes et al , 1987 and 1988 ; Brandi , 1981 ) it is clear that external surface crack initiation in ...
Page 499
... stiffened T joints at N , could be less than one quarter of their load capacity when intact . TABLE 13 LOWER BOUND ESTIMATES OF REMAINING CHORD LIGAMENT IN STIFFENED AND UNSTIFFENED T JOINTS AT FRACTIONS OF N , Remaining chord ligament ...
... stiffened T joints at N , could be less than one quarter of their load capacity when intact . TABLE 13 LOWER BOUND ESTIMATES OF REMAINING CHORD LIGAMENT IN STIFFENED AND UNSTIFFENED T JOINTS AT FRACTIONS OF N , Remaining chord ligament ...
Page 501
... stiffened tubular T joint specimen was tested to failure under axial tension brace loading . The specimen failed by ductile tearing of the remaining uncracked ligament . The effective chord ligament area in the cracked condition was ...
... stiffened tubular T joint specimen was tested to failure under axial tension brace loading . The specimen failed by ductile tearing of the remaining uncracked ligament . The effective chord ligament area in the cracked condition was ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength