Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 82
Page 154
... surface . FIGURE 05 - ASPECT OF FRACTURED SURFACE - a 13.68 kgf / mm2 FOR 600 ° C . FIGURE 04 - ASPECT OF FRACTURED SURFACE -0-50,51 kgf / mm2 FOR 500 ° C In the two cases reported in ( Figure 04 ) , the aspect of the fractured surfaces ...
... surface . FIGURE 05 - ASPECT OF FRACTURED SURFACE - a 13.68 kgf / mm2 FOR 600 ° C . FIGURE 04 - ASPECT OF FRACTURED SURFACE -0-50,51 kgf / mm2 FOR 500 ° C In the two cases reported in ( Figure 04 ) , the aspect of the fractured surfaces ...
Page 159
... surface of tensile test specimen . relationship between the fracture load P , and the coating thickness 1. Fracture type described above is also specified in the figure . To investigate the reason for different fracture behaviors at 3PB ...
... surface of tensile test specimen . relationship between the fracture load P , and the coating thickness 1. Fracture type described above is also specified in the figure . To investigate the reason for different fracture behaviors at 3PB ...
Page 273
... SURFACE. Flank Wear Vb ( mm ) 1,4 1,2 1 0,8 0,6 0,4 0,2 0 2 20 22 A1203 + ZrO2 A1203 + TIC A1203 + SiC M Duro K10 CBN PCD all the tool materials tested . For some tool materials the rate of increase machining force is remarkable ...
... SURFACE. Flank Wear Vb ( mm ) 1,4 1,2 1 0,8 0,6 0,4 0,2 0 2 20 22 A1203 + ZrO2 A1203 + TIC A1203 + SiC M Duro K10 CBN PCD all the tool materials tested . For some tool materials the rate of increase machining force is remarkable ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength