Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 15, Part 3American Society of Mechanical Engineers, 1996 - Arctic regions |
From inside the book
Results 1-3 of 82
Page 117
... values . For the ferritic steel welds , the HAZ hardness was always highest at the cap , with mean values ranging from 394 HV10 to 422 HV10 . However , the mean HAZ hardness for the austenitic stainless steel weld was greatest in the ...
... values . For the ferritic steel welds , the HAZ hardness was always highest at the cap , with mean values ranging from 394 HV10 to 422 HV10 . However , the mean HAZ hardness for the austenitic stainless steel weld was greatest in the ...
Page 328
... values for this data . John Brown have also attempted to apply A and m values from the original experimental work by Booth and Dobbs ( Ref . 22 ) , but the results have not invariably reduced conservatism or given results easier to ...
... values for this data . John Brown have also attempted to apply A and m values from the original experimental work by Booth and Dobbs ( Ref . 22 ) , but the results have not invariably reduced conservatism or given results easier to ...
Page 416
... values . Higher impact toughness values were related to higher a'- martensite contents . Low impact toughness values of cold - rolled AISI 304LN steel at -135 and -196 ° C were not due to a'- martensite formation during cooling prior to ...
... values . Higher impact toughness values were related to higher a'- martensite contents . Low impact toughness values of cold - rolled AISI 304LN steel at -135 and -196 ° C were not due to a'- martensite formation during cooling prior to ...
Contents
CODES AND STANDARDS | 1 |
EFFECT OF WELDING PARAMETERS ON JOINT PROPERTIES | 35 |
UNDERWATER WELDING AND REPAIR | 85 |
Copyright | |
9 other sections not shown
Other editions - View all
Common terms and phrases
a'-martensite analysis applied as-welded assessment austenite Axial tension base metal behaviour bending brace brittle butt welds cathodic protection CFRC chord crack cold-rolling composition corrosion corrosion fatigue crack depth crack growth rates crack initiation crack tip cracked joints CTOD curve cycles defects effect electrode Engineering equations evaluation experimental failure fatigue crack growth fatigue tests ferrite Figure fracture mechanics fracture toughness geometry heat affected zone heat treatment high strength steels hydrogen increased inspection martensite material measured microstructure mis-match notch offshore structures parameters performance pipe predicted pressure procedure PWHT ratio reduced residual stresses riser root S-N curves saddle seawater shielding gas shown simulation specimens static strength stiffened joints stress intensity factor surface crack Table temperature tensile thickness titanium alloys tubular joints ultrasonic unstiffened values weld joint weld metal weld toe weldments wide plates yield strength