## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 2002 - Arctic regions |

### From inside the book

Results 1-3 of 84

Page 45

In this work a stress ratio R = 0.8 was adopted , where R is the ratio between the

minimum stress ( Omin ) and

defined as half difference between

In this work a stress ratio R = 0.8 was adopted , where R is the ratio between the

minimum stress ( Omin ) and

**maximum**stress ( O max ) . Alternate stress ( 02 ) isdefined as half difference between

**maximum**and minimum stresses , in this ...Page 56

The associated

be : angles . The new slip model seem to work satisfactory with respect to

correctly describing the transition from the stick to the slip regime . Position 00

700 ...

The associated

**maximum**longitudinal wire displacement at slip onset is found tobe : angles . The new slip model seem to work satisfactory with respect to

correctly describing the transition from the stick to the slip regime . Position 00

700 ...

Page 250

The residual stress is relaxed for a tensile stressed specimen maintaining the

constant

from the surface . However , the pushing force appears as increases in the

applied ...

The residual stress is relaxed for a tensile stressed specimen maintaining the

constant

**maximum**depth , h ,, as the stress relaxation pushes the indenter outfrom the surface . However , the pushing force appears as increases in the

applied ...

### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Other editions - View all

### Common terms and phrases

alloys analysis applied approximately assessment bending calculated carried coating compared composite compressive considered corrosion crack crack growth curve cycles damage defect deformation depth determined developed direction distribution effect element Engineering equation estimated evaluation experience factor failure fatigue field Figure flaw flexible fracture function geometry given Grade heat higher hydrogen important increase initial installation insulation integrity International joint length limit load locations lower material maximum mean measured mechanical method observed obtained Offshore operation parameters performed pipe plate predicted present pressure problem procedure production properties range reliability residual resistance respectively riser rope safety samples shown shows side simulation solution specimens standard steel strain strength stress structure surface Table temperature tensile tension thermal thickness titanium toughness uncertainties variables weld