Solid State Behavior of Linear Polyesters and Polyamides |
From inside the book
Results 1-3 of 56
Page 46
... samples Nos . 3 , 5 , and 7 , the T value of sample No. 4 was used , Table 10 ) . The results are also presented in Table 10. Taking into account that these very close 1. values were obtained from samples differing in size , contact ...
... samples Nos . 3 , 5 , and 7 , the T value of sample No. 4 was used , Table 10 ) . The results are also presented in Table 10. Taking into account that these very close 1. values were obtained from samples differing in size , contact ...
Page 51
... sample during scanning in the calorimeter . To estimate the extent to which the healing effect is caused by the chemical reaction , experiments were conducted with already crosslinked polyamide samples [ 179 ] . A summary of ...
... sample during scanning in the calorimeter . To estimate the extent to which the healing effect is caused by the chemical reaction , experiments were conducted with already crosslinked polyamide samples [ 179 ] . A summary of ...
Page 55
... samples were heat treated ( second annealing or healing , Table 13 , samples 4 , 11 , and 15 ) and DSC thermograms were then taken . Thermograms were also taken of non - crosslinked samples ( Table 13 , sam- ples 3 , 12 , and 13 ) with ...
... samples were heat treated ( second annealing or healing , Table 13 , samples 4 , 11 , and 15 ) and DSC thermograms were then taken . Thermograms were also taken of non - crosslinked samples ( Table 13 , sam- ples 3 , 12 , and 13 ) with ...
Contents
SOLID STATE REACTIONS IN LINEAR | 1 |
CHEMICAL HEALING | 43 |
PRACTICAL ASPECTS OF ADDITIONAL SOLID STATE | 59 |
Copyright | |
19 other sections not shown
Common terms and phrases
acid additional solid amorphous annealing Appl aspect ratio behavior birefringence block temperature chain Chem composites copolyester copolymer courtesy crystallinity crystallization curves decreases deformation degree of crystallinity density diameter diffusion domains Dröscher effect Equation exchange reactions extrusion temperature Fakirov fiber axis fibers drawn filament fracture mechanics fracture toughness function heat of fusion heated element higher increasing initial kg/cm² kinetics linear polycondensates load macromolecules Makromol material matrix maximum measurements mechanical melting point microfibrils microstructure mm/min modulus molded molecules morphology nominal draw ratio noncrystalline nylon 6 fibers nylon 66 orientation parameters peak PET fibers phase Phys polyamides polyesters Polymer Sci polymerization properties Reprinted from Ref samples SAXS Schultz semicrystalline shown in Figure solid state polycondensation solid state post-polycondensation solid state reactions Solid-state extrusion specimen spherulite strength stress structure Table tensile terephthalate thermoplastics toughened transesterification transreactions values x-ray yield Zachmann