Solid State Behavior of Linear Polyesters and Polyamides |
From inside the book
Results 1-3 of 50
Page 198
... strengths . 12 11 10 Strength , G / D Q ∞ 7 6 5 50 100 150 3.5X 3.0X 2.3X 200 First Stage Block Temperature , ° C Figure 41. Effect of first stage block temperature on the strength of fully drawn yarn in two state drawing . Reprinted ...
... strengths . 12 11 10 Strength , G / D Q ∞ 7 6 5 50 100 150 3.5X 3.0X 2.3X 200 First Stage Block Temperature , ° C Figure 41. Effect of first stage block temperature on the strength of fully drawn yarn in two state drawing . Reprinted ...
Page 200
... strength vs. block ( or exit ) temperature ( Figure 41 ) reveals a striking similarity . In both cases , there is little effect on strength when the temperature is varied between 25 and 125 ° C , and the maximum filament strength is ...
... strength vs. block ( or exit ) temperature ( Figure 41 ) reveals a striking similarity . In both cases , there is little effect on strength when the temperature is varied between 25 and 125 ° C , and the maximum filament strength is ...
Page 201
... strength . Reprinted from Ref . [ 52 ] by courtesy of The Society of Plastic Engineers . strength . In addition , the maximum draw ratio increases monotonically with the increasing block temperature up to the onset of strength loss ...
... strength . Reprinted from Ref . [ 52 ] by courtesy of The Society of Plastic Engineers . strength . In addition , the maximum draw ratio increases monotonically with the increasing block temperature up to the onset of strength loss ...
Contents
SOLID STATE REACTIONS IN LINEAR | 1 |
CHEMICAL HEALING | 43 |
PRACTICAL ASPECTS OF ADDITIONAL SOLID STATE | 59 |
Copyright | |
19 other sections not shown
Common terms and phrases
acid additional solid amorphous annealing Appl aspect ratio behavior birefringence block temperature chain Chem composites copolyester copolymer courtesy crystallinity crystallization curves decreases deformation degree of crystallinity density diameter diffusion domains Dröscher effect Equation exchange reactions extrusion temperature Fakirov fiber axis fibers drawn filament fracture mechanics fracture toughness function heat of fusion heated element higher increasing initial kg/cm² kinetics linear polycondensates load macromolecules Makromol material matrix maximum measurements mechanical melting point microfibrils microstructure mm/min modulus molded molecules morphology nominal draw ratio noncrystalline nylon 6 fibers nylon 66 orientation parameters peak PET fibers phase Phys polyamides polyesters Polymer Sci polymerization properties Reprinted from Ref samples SAXS Schultz semicrystalline shown in Figure solid state polycondensation solid state post-polycondensation solid state reactions Solid-state extrusion specimen spherulite strength stress structure Table tensile terephthalate thermoplastics toughened transesterification transreactions values x-ray yield Zachmann