Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 331
... compared to the test results . The failure mode was the same as for a similar welded node , i.e. ovalization of the chord . Increased segment thickness , K - node . Increasing the segment thickness by 33 % increased the ultimate ...
... compared to the test results . The failure mode was the same as for a similar welded node , i.e. ovalization of the chord . Increased segment thickness , K - node . Increasing the segment thickness by 33 % increased the ultimate ...
Page 332
... compared to simple node geometry . Complex node geometry has an effect on the SCF in the fillet and chord in weld area . compared An to increase SCF up to 70 % , simple node geometry , was found . Loads in the chord may have a ...
... compared to simple node geometry . Complex node geometry has an effect on the SCF in the fillet and chord in weld area . compared An to increase SCF up to 70 % , simple node geometry , was found . Loads in the chord may have a ...
Page 389
... compared with the single - wire process . Since there are two arcs in the twin - wire process , the melting due to arc heating is the same for both processes . However , the second component of the heating , i.e. melting due to ...
... compared with the single - wire process . Since there are two arcs in the twin - wire process , the melting due to arc heating is the same for both processes . However , the second component of the heating , i.e. melting due to ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
42 other sections not shown
Other editions - View all
Common terms and phrases
applications as-welded ASTM axial load behaviour bending brace calculated chord components Composite Materials compression Conoco Inc corrosion rate crack depth crack length crack propagation CTOD damage delamination elastomer Engineering experimental failure fatigue design fatigue strength fatigue tests Figure finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress increase intersection laminate Marine matrix maximum mean stress method mode modulus nominal normal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress pultrusion ratio rebar reinforcement Research resin resistance ring stiffened riser rubber S-N curve seal shear stress shown in Fig specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique Technology tensile strength tension thickness effect tube tubular joints weld profile weld toe welded joints yield strength zone