Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 81
Page 85
... developed at these strength ranges , none have been developed for specific use in arctic offshore structures . This paper presents the results of the mix design development for all three concretes . Salient properties of fresh concrete ...
... developed at these strength ranges , none have been developed for specific use in arctic offshore structures . This paper presents the results of the mix design development for all three concretes . Salient properties of fresh concrete ...
Page 511
... developed for depths in the range 70-360 meters below surphase ( msw ) . The mechanical welding system has also been developed for the following important reasons : 1. To have an operational emergency system in case of a pipeline repair ...
... developed for depths in the range 70-360 meters below surphase ( msw ) . The mechanical welding system has also been developed for the following important reasons : 1. To have an operational emergency system in case of a pipeline repair ...
Page 587
... developed by BHP Steel for offshore structures , offering improved weldability and satisfying minimum yield strengths of 345 MPa and 500 MPa , and Charpy impact toughness at -40 ° C . The 345 MPa grade is a C - Mn - Cu - Ni - Nb - Ti ...
... developed by BHP Steel for offshore structures , offering improved weldability and satisfying minimum yield strengths of 345 MPa and 500 MPa , and Charpy impact toughness at -40 ° C . The 345 MPa grade is a C - Mn - Cu - Ni - Nb - Ti ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone