Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 81
Page 185
... Effects of post weld treatment and weld profiling are summarized . Thickness effect clauses in European design codes for offshore structures are reviewed , and trends for further development are indicated . INTRODUCTION The thickness effect ...
... Effects of post weld treatment and weld profiling are summarized . Thickness effect clauses in European design codes for offshore structures are reviewed , and trends for further development are indicated . INTRODUCTION The thickness effect ...
Page 689
... effect , the technological effect and the geometrical size effect . an The statistical effect is associated with the higher probability of Occurrence of a large defect in increased volume of material , resulting in lower strength for ...
... effect , the technological effect and the geometrical size effect . an The statistical effect is associated with the higher probability of Occurrence of a large defect in increased volume of material , resulting in lower strength for ...
Page 692
... effect is in this case nearly the same as in the SAE rule with n 0.102 . Technological size effects . Specimens cut from large billets are known to have lower strength than specimens from the same material rolled or forged to thinner ...
... effect is in this case nearly the same as in the SAE rule with n 0.102 . Technological size effects . Specimens cut from large billets are known to have lower strength than specimens from the same material rolled or forged to thinner ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone