Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 89
Page 64
... Element 448 Element 449 △ Element 450 1 0.9 0.8 0.7 0.6 Failure Index 1.2 1.1 1 0.9 0.8 0.7 0.6 Element 447 + Element 448 Element 449 △ Element 450 45 ° 0.5 0.4- 0.5 0.3- 0.4 0.3 0.2- 0.2 0.1- 0.1 O 0 0.2 0.4 0.6 O 0.2 Beam Pressure ...
... Element 448 Element 449 △ Element 450 1 0.9 0.8 0.7 0.6 Failure Index 1.2 1.1 1 0.9 0.8 0.7 0.6 Element 447 + Element 448 Element 449 △ Element 450 45 ° 0.5 0.4- 0.5 0.3- 0.4 0.3 0.2- 0.2 0.1- 0.1 O 0 0.2 0.4 0.6 O 0.2 Beam Pressure ...
Page 65
... Element 448 Element 449 △ Element 450 45 ° 1 0.8 0.6 0.4 0.2 0 0.2 0.4 0.6 Beam Pressure , MPa ply from the midplane in the 90 ° layer of the Layup 1 Îaminate . The Layup 2 laminate shows an insignificant normal stress through the ...
... Element 448 Element 449 △ Element 450 45 ° 1 0.8 0.6 0.4 0.2 0 0.2 0.4 0.6 Beam Pressure , MPa ply from the midplane in the 90 ° layer of the Layup 1 Îaminate . The Layup 2 laminate shows an insignificant normal stress through the ...
Page 321
... element stress analysis of tubular joints is usually carried out using thin shell elements . This type of element accurately models the geometry and structural behaviour of the tubulars in most parts of the joints , however , at the ...
... element stress analysis of tubular joints is usually carried out using thin shell elements . This type of element accurately models the geometry and structural behaviour of the tubulars in most parts of the joints , however , at the ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
42 other sections not shown
Other editions - View all
Common terms and phrases
applications as-welded ASTM axial load behaviour bending brace calculated chord components Composite Materials compression Conoco Inc corrosion rate crack depth crack length crack propagation CTOD damage delamination elastomer Engineering experimental failure fatigue design fatigue strength fatigue tests Figure finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress increase intersection laminate Marine matrix maximum mean stress method mode modulus nominal normal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress pultrusion ratio rebar reinforcement Research resin resistance ring stiffened riser rubber S-N curve seal shear stress shown in Fig specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique Technology tensile strength tension thickness effect tube tubular joints weld profile weld toe welded joints yield strength zone