Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 83
Page 11
... force of 100 kN . A great number of locations and direc- tions of the force were analysed . Overtrawling of the WPS with the two trawl boards passing on each side of the structure . See Fig . 1. This case was simulated by a horizontal ...
... force of 100 kN . A great number of locations and direc- tions of the force were analysed . Overtrawling of the WPS with the two trawl boards passing on each side of the structure . See Fig . 1. This case was simulated by a horizontal ...
Page 304
... force so that only a slight axial force was required to maintain contact as the branches deflected . Compression in the chord was applied with four rams mounted on one end plate , acting upon tension rods which ran the length of the ...
... force so that only a slight axial force was required to maintain contact as the branches deflected . Compression in the chord was applied with four rams mounted on one end plate , acting upon tension rods which ran the length of the ...
Page 394
... force is selected to achieve an apparent contact pressure at the weld interface of approximately 34.5 MPa . Upset force is based on parent metal yield strength at welding temperature . The force profile -- the timing of application of upset ...
... force is selected to achieve an apparent contact pressure at the weld interface of approximately 34.5 MPa . Upset force is based on parent metal yield strength at welding temperature . The force profile -- the timing of application of upset ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
42 other sections not shown
Other editions - View all
Common terms and phrases
applications as-welded ASTM axial load behaviour bending brace calculated chord components Composite Materials compression Conoco Inc corrosion rate crack depth crack length crack propagation CTOD damage delamination elastomer Engineering experimental failure fatigue design fatigue strength fatigue tests Figure finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress increase intersection laminate Marine matrix maximum mean stress method mode modulus nominal normal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress pultrusion ratio rebar reinforcement Research resin resistance ring stiffened riser rubber S-N curve seal shear stress shown in Fig specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique Technology tensile strength tension thickness effect tube tubular joints weld profile weld toe welded joints yield strength zone