Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 77
Page 73
... indicate that the insensitivity of the material to water is partially due to the fact that the interface is the site of failure , even for dry specimens . This may also account for the lower transverse tensile strength for dry specimens ...
... indicate that the insensitivity of the material to water is partially due to the fact that the interface is the site of failure , even for dry specimens . This may also account for the lower transverse tensile strength for dry specimens ...
Page 332
... indicate a reduced SCF at the brace weld compared to a welded node . For the fillet the results indicate an increase in the SCF for forged nodes compared to welded nodes . The fillet area is , however , base metal with better fatigue ...
... indicate a reduced SCF at the brace weld compared to a welded node . For the fillet the results indicate an increase in the SCF for forged nodes compared to welded nodes . The fillet area is , however , base metal with better fatigue ...
Page 412
... indicate the thickness coating of all the wires is around minimum requirement . The indicates the uniformity of the coating . The specimens J1 & J2 indicate more uniform coating than the rest of the specimens . So in the beginning we ...
... indicate the thickness coating of all the wires is around minimum requirement . The indicates the uniformity of the coating . The specimens J1 & J2 indicate more uniform coating than the rest of the specimens . So in the beginning we ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone