## Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |

### From inside the book

Results 1-3 of 80

Page 18

The Heat Distortion Temperature ( HDT ) would be an appropriate

The Heat Distortion Temperature ( HDT ) would be an appropriate

**limit**. ... In this case an analysis should be carried out which shows that the inservice loads can be carried by that portion of the laminate within the required**limits**.Page 277

FATIGUE

FATIGUE

**LIMIT**PREDICTION FOR BOLTS IN TENSION E. A. Patterson Department of Mechanical and Process Engineering University of ... Abstract Suco Sut α , αν Some methods for predicting the fatigue**limits**of bolt - nut connections have been ...Page 280

Discussion ( a ) Reliability and Statistical Effects All the methods of predicting the fatigue

Discussion ( a ) Reliability and Statistical Effects All the methods of predicting the fatigue

**limits**aim to ... Assuming a sample size of 6 it is possible to state , with 99 % confidence , that the mean fatigue**limit**lies within a band ...### What people are saying - Write a review

We haven't found any reviews in the usual places.

### Contents

ADVANCED COMPOSITES | 1 |

The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |

Low Cost Manufactruring Technology for FireResistant Phenolic Matrix Composites | 21 |

Copyright | |

47 other sections not shown

### Other editions - View all

### Common terms and phrases

analysis applications approach axial behaviour bending brace calculated chord combined compared components composite compression concrete connection considered construction corrosion crack growth critical curve cycles damage depth determined direction distribution effect Engineering experimental factor failure fatigue fiber Figure finite element force fracture fracture mechanics geometry increase indicate initial internal intersection length limit load lower material maximum mean measured mechanics metal method mode nodes nominal normal notch observed obtained offshore offshore structures parameters performance pipe plate position predicted present pressure procedure production properties range ratio reduced reinforcement Research resistance seal shear shell shown shows specimens steel stiffener strain strength stress concentration structures surface Table technique temperature tension thickness thread tube tubular joints weight weld