Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 84
Page 44
... mechanics on damage tolerance of composite structures with ply terminations is shown in Fig . 14. In this figure , the influence of GIC and GIIC on critical load at the onset of delamination growth is quantified . The range of toughness ...
... mechanics on damage tolerance of composite structures with ply terminations is shown in Fig . 14. In this figure , the influence of GIC and GIIC on critical load at the onset of delamination growth is quantified . The range of toughness ...
Page 261
... mechanics ( LEFM ) conditions and those conditions associated with nonlinear elastic fracture mechanics . These data provide the basis for evaluating the ability to predict integrity of structural components containing natural defects ...
... mechanics ( LEFM ) conditions and those conditions associated with nonlinear elastic fracture mechanics . These data provide the basis for evaluating the ability to predict integrity of structural components containing natural defects ...
Page 386
... Mechanics / Analysis Design Methods of Structures Prototype Structures Computer Technology / Expert Systems VOLUME II SAFETY AND RELIABILITY Probabilistic Load Modeling Reliability - Based Design and Inspection Probabilistic Response ...
... Mechanics / Analysis Design Methods of Structures Prototype Structures Computer Technology / Expert Systems VOLUME II SAFETY AND RELIABILITY Probabilistic Load Modeling Reliability - Based Design and Inspection Probabilistic Response ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
42 other sections not shown
Other editions - View all
Common terms and phrases
applications as-welded ASTM axial load behaviour bending brace calculated chord components Composite Materials compression Conoco Inc corrosion rate crack depth crack length crack propagation CTOD damage delamination elastomer Engineering experimental failure fatigue design fatigue strength fatigue tests Figure finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress increase intersection laminate Marine matrix maximum mean stress method mode modulus nominal normal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress pultrusion ratio rebar reinforcement Research resin resistance ring stiffened riser rubber S-N curve seal shear stress shown in Fig specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique Technology tensile strength tension thickness effect tube tubular joints weld profile weld toe welded joints yield strength zone