Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 57
Page 332
... nodes are 15-25 % higher nodes . Fatigue Strength Tension 6.696 E7 8.220 E7 8.412 E7 the capacity of than for the welded the Fatigue evaluation of the brace weld in complex nodes may be performed based on SCF of simple node geometry and ...
... nodes are 15-25 % higher nodes . Fatigue Strength Tension 6.696 E7 8.220 E7 8.412 E7 the capacity of than for the welded the Fatigue evaluation of the brace weld in complex nodes may be performed based on SCF of simple node geometry and ...
Page 338
... nodes over the traditional welded ones are the following : Stress Concentration Factors ( SCF ) are lower for forged nodes than for welded nodes as a result of the more regular transition between the brace and the chord ; the forged node ...
... nodes over the traditional welded ones are the following : Stress Concentration Factors ( SCF ) are lower for forged nodes than for welded nodes as a result of the more regular transition between the brace and the chord ; the forged node ...
Page 339
... nodes . The detailed design of the forged nodes may require a more general and rational fatigue analysis where the complex node behaviour is fully considered and the check of different welds or of high stressed positions of the base ...
... nodes . The detailed design of the forged nodes may require a more general and rational fatigue analysis where the complex node behaviour is fully considered and the check of different welds or of high stressed positions of the base ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone