Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 79
Page 256
... plate test . The wide plate tests were carried out at temperatures where the critical CTOD value obtained from the small scale CTOD test was in the range of from 0.1mm to 1.0mm . EXPERIMENTAL RESULT Figure 5 shows the variation of ...
... plate test . The wide plate tests were carried out at temperatures where the critical CTOD value obtained from the small scale CTOD test was in the range of from 0.1mm to 1.0mm . EXPERIMENTAL RESULT Figure 5 shows the variation of ...
Page 450
... plate thickness effect on CTOD is expressed by 8CB / 8c1 = ( 2/3 ) ( 1 + n ) / n [ 0.79 + x ( x − 1.3 ) ] ( 1 - nNo2n x [ 0.85 - x / 21 / 0.71 / m where x = ( 1 - h ) / 2 h = 10.2 / ( B + 5.2 ) for B > 10mm , B - plate thickness ( mm ) ...
... plate thickness effect on CTOD is expressed by 8CB / 8c1 = ( 2/3 ) ( 1 + n ) / n [ 0.79 + x ( x − 1.3 ) ] ( 1 - nNo2n x [ 0.85 - x / 21 / 0.71 / m where x = ( 1 - h ) / 2 h = 10.2 / ( B + 5.2 ) for B > 10mm , B - plate thickness ( mm ) ...
Page 587
... Plates up to 50mm thick have been produced achieving yield strengths in excess of 500 MPa and high Charpy toughness at -40 ° C , combined with good weldability . INTRODUCTION BHP Steel has been supplying plate steels for the ...
... Plates up to 50mm thick have been produced achieving yield strengths in excess of 500 MPa and high Charpy toughness at -40 ° C , combined with good weldability . INTRODUCTION BHP Steel has been supplying plate steels for the ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone