Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 46
Page 99
... reinforcement . The cracks caused due to the rust product of the embedded steel corrosion will normally occur along the length of the reinforcing bar . The width and length of the cracks will depend on the amount of rust products and ...
... reinforcement . The cracks caused due to the rust product of the embedded steel corrosion will normally occur along the length of the reinforcing bar . The width and length of the cracks will depend on the amount of rust products and ...
Page 109
... reinforcement . To maintain the high concrete quality after casting the workability of the concrete mix in increased from a slump a in the range of 100-120mm to 220-250mm . The development in workability has been made possible first of ...
... reinforcement . To maintain the high concrete quality after casting the workability of the concrete mix in increased from a slump a in the range of 100-120mm to 220-250mm . The development in workability has been made possible first of ...
Page 110
Reinforcement corrosion resistance . The combination of steel and sea water has an inherent corrosion potential . However if the steel is embedded in sound concrete the corrosion potential is for all practical purposes reduced to almost ...
Reinforcement corrosion resistance . The combination of steel and sea water has an inherent corrosion potential . However if the steel is embedded in sound concrete the corrosion potential is for all practical purposes reduced to almost ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
42 other sections not shown
Other editions - View all
Common terms and phrases
applications as-welded ASTM axial load behaviour bending brace calculated chord components Composite Materials compression Conoco Inc corrosion rate crack depth crack length crack propagation CTOD damage delamination elastomer Engineering experimental failure fatigue design fatigue strength fatigue tests Figure finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress increase intersection laminate Marine matrix maximum mean stress method mode modulus nominal normal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress pultrusion ratio rebar reinforcement Research resin resistance ring stiffened riser rubber S-N curve seal shear stress shown in Fig specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique Technology tensile strength tension thickness effect tube tubular joints weld profile weld toe welded joints yield strength zone