Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 88
Page 210
... Figure 1 , are shown in Figure 5 with extrapolation to the hot spot strain according to the ECSC and DnV procedures respectively , cf. Figure 3 and 4. The data are assessed on the basis of actual cross section , i.e. including internal ...
... Figure 1 , are shown in Figure 5 with extrapolation to the hot spot strain according to the ECSC and DnV procedures respectively , cf. Figure 3 and 4. The data are assessed on the basis of actual cross section , i.e. including internal ...
Page 454
... shown in Figure 3 , were notched at the weld metal and CGHAZ . The notches were prepared with the help of a small drilled hole at the centre and extended by a 0.3 mm wide spark cutting . The a / W ratios were used as 0.1 , 0.3 and 0.5 ...
... shown in Figure 3 , were notched at the weld metal and CGHAZ . The notches were prepared with the help of a small drilled hole at the centre and extended by a 0.3 mm wide spark cutting . The a / W ratios were used as 0.1 , 0.3 and 0.5 ...
Page 455
... Figures firstly indicate that almost no measurable plastic strain occured in the base plate cross - sections and that the applied strain was entirely taken by the undermatched weld region . This behaviour was already shown in Figure 9 ...
... Figures firstly indicate that almost no measurable plastic strain occured in the base plate cross - sections and that the applied strain was entirely taken by the undermatched weld region . This behaviour was already shown in Figure 9 ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone