Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 3American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 81
Page 192
... specimen fabrication , employing electrodes complying with BS 639 : 1976 E51 44B 24H ( AWS A5.1 E7018 ) . A preheat tem- perature of 100 C was used to weld specimens from plates 38mm thick and greater . All specimens were fab- ricated ...
... specimen fabrication , employing electrodes complying with BS 639 : 1976 E51 44B 24H ( AWS A5.1 E7018 ) . A preheat tem- perature of 100 C was used to weld specimens from plates 38mm thick and greater . All specimens were fab- ricated ...
Page 201
... specimens superimpose ( Figure 12 ) , indicating that for this thickness range improved profiling has nullified any effect from the increase in plate thickness . Figures 13 and 14 present data for 51 mm thick specimens . The former ...
... specimens superimpose ( Figure 12 ) , indicating that for this thickness range improved profiling has nullified any effect from the increase in plate thickness . Figures 13 and 14 present data for 51 mm thick specimens . The former ...
Page 454
... specimens were aimed to sample the CGHAZ adjacent to the straight sides of the weld beads . The CCT panels ( 12 of them ) as shown in Figure 3 , were notched at the weld metal and CGHAZ . The notches were prepared with the help of a ...
... specimens were aimed to sample the CGHAZ adjacent to the straight sides of the weld beads . The CCT panels ( 12 of them ) as shown in Figure 3 , were notched at the weld metal and CGHAZ . The notches were prepared with the help of a ...
Contents
ADVANCED COMPOSITES | 1 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
Low Cost Manufacturing Technology for FireResistant Phenolic Matrix Composites | 21 |
Copyright | |
25 other sections not shown
Other editions - View all
Common terms and phrases
applied as-welded ASTM axial load behaviour bending brace calculated components Composite Materials compression concrete Conoco Inc corrosion rate crack depth crack propagation CTOD cycles damage delamination developed elastomer Engineering experimental failure fatigue design fatigue limit fatigue strength fatigue tests finite element analysis forged nodes fracture mechanics fracture toughness geometry hot spot stress intersection laminate Marine matrix maximum mean stress method mode modulus nominal notch obtained offshore structures parameters performance pipe plate thickness platform pre-load predicted pressure principal stress properties pultrusion ratio rebar reinforcement resin resistance ring stiffened riser rubber S-N curve seal shear stress shell elements shown in Figure specimens steel stiffness strain stress analysis stress concentration stress concentration factor stress intensity factor stress range surface crack T-joint Table technique tensile tension thickness effect threaded joint tube tubular joints weld profile weld toe welded joints yield strength zone