Mechanical Metallurgy 
From inside the book
Results 13 of 83
Page 206
The onset of general yielding occurs at a stress where the average dislocation
sources can create slip bands through a good volume of the material. Thus, the
general yield stress can be expressed as <r0 = a, + a, (616) where as is the
stress ...
The onset of general yielding occurs at a stress where the average dislocation
sources can create slip bands through a good volume of the material. Thus, the
general yield stress can be expressed as <r0 = a, + a, (616) where as is the
stress ...
Page 243
begin at the stress corresponding to point E, which is appreciably lower than the
original compressive yield stress of the material. While the yield stress in tension
was increased by strain hardening from A to C, the yield stress in compression ...
begin at the stress corresponding to point E, which is appreciably lower than the
original compressive yield stress of the material. While the yield stress in tension
was increased by strain hardening from A to C, the yield stress in compression ...
Page 311
of yielding on the hydrostatic component of the stress state. We have seen (Sec.
35) how the von Mises' criterion may be modified to account for anisotropy. In
annealed metals the second assumption is usually reasonable, but in polymers, ...
of yielding on the hydrostatic component of the stress state. We have seen (Sec.
35) how the von Mises' criterion may be modified to account for anisotropy. In
annealed metals the second assumption is usually reasonable, but in polymers, ...
What people are saying  Write a review
User ratings
5 stars 
 
4 stars 
 
3 stars 
 
2 stars 
 
1 star 

User Review  Flag as inappropriate
One of the best book for Mechanical Metallurgy. All metallurgist should have a copy of this book.
User Review  Flag as inappropriate
000108
Contents
Introduction  3 
Elements of the Theory of Plasticity  72 
Plastic Deformation of Single Crystals  105 
Copyright  
20 other sections not shown
Other editions  View all
Common terms and phrases
alloys angle annealed atoms axes axis behavior billet brittle fracture Burgers vector coldworked components compression constant crack criterion cross slip cycles decrease determined diameter direction dislocation line ductile edge dislocation elastic elongation energy engineering equations extrusion factor failure fatigue limit fibers flow curve flow stress force forging friction given grain boundaries hotworking hydrostatic increases lattice length load machining martensite material matrix maximum measured mechanical metallurgical Metals Park modulus normal stress notch occurs orientation particles percent plastic deformation plastic strain polymer pressure produced properties ratio reduction region residual stresses rolling screw dislocation shear strain shear stress sheet shown in Fig shows slip plane slip systems Society for Metals solid specimen steel strain hardening strain rate stressstrain curve structure surface tensile strength tensile stress tensor theory thermal thickness tool torsion Trans usually velocity workpiece yield strength yield stress York