Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 4American Society of Mechanical Engineers, 1988 - Arctic regions |
From inside the book
Results 1-3 of 27
Page 13
... oriented thin section of Block 3 , Core 1 shown by cross polarized illumnination The section was taken in the upper 1-3 cm of the core . 1 CM Tensile Sample Preparation In order to apply a uniaxial tensile load , phenolic resin ...
... oriented thin section of Block 3 , Core 1 shown by cross polarized illumnination The section was taken in the upper 1-3 cm of the core . 1 CM Tensile Sample Preparation In order to apply a uniaxial tensile load , phenolic resin ...
Page 14
... oriented samples produced nearly linear curves which terminated in fracture after very little strain ( < 2x 104 ) . At the lower strain rate , the curves for vertically oriented samples had negative curvature and terminated at ...
... oriented samples produced nearly linear curves which terminated in fracture after very little strain ( < 2x 104 ) . At the lower strain rate , the curves for vertically oriented samples had negative curvature and terminated at ...
Page 16
... oriented samples and from 0.28 ± 0.06 MPa at 10-7s - 1 to 0.35 ± 0.15 MPa at 10-3s - 1 for horizontally oriented samples . 4. Vertically oriented samples have a tensile strength three to four times larger than that of horizontally oriented ...
... oriented samples and from 0.28 ± 0.06 MPa at 10-7s - 1 to 0.35 ± 0.15 MPa at 10-3s - 1 for horizontally oriented samples . 4. Vertically oriented samples have a tensile strength three to four times larger than that of horizontally oriented ...
Contents
OFFSHORE MECHANICS | 1 |
The Structure and Tensile Behavior of First Year Sea Ice and LaboratoryGrown Saline | 11 |
Effects of Temperature and Strain Rate on Uniaxial Compressive Strength of Naturally Formed Fresh | 19 |
Copyright | |
26 other sections not shown
Other editions - View all
Common terms and phrases
analysis Arctic Engineering average beam Beaufort Sea Bering Sea caisson crack creep curves deflection deformation diameter dome drift dynamic effect elastic modulus energy equation estimate experimental extreme value distribution factor failure flexural strength floe fracture toughness freezing friction coefficient gauges geostrophic wind horizontal ice crushing ice domes ice drift ice edge ice force Ice Impact ice loads ice motion ice pressure ice sheet ice thickness ice velocity iceberg icebreaking increase indentation interaction island layer linear measured Mechanics and Arctic method MIZEX model ice model tests modulus Molikpaq normal force ocean Offshore Mechanics parameters peak plastic platform pressure panel PVDF ratio reinforced ice Research saline samples scale sea ice sediments shear shear strength ship shown in Figure specimen speed spray ice strain gauges strain rate stress structure surface temperature tensor thermosyphon Timco tion uniaxial values vertical wind