Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 80
Page 57
081 refinement ( see Figure 4 ) ( 3 ) . This is not reflected in an improvement of
the fracture toughness in HAZ and CR . However , the SEM analysis of tested
specimens has indicated significant differences in fracture surface roughness ,
crack ...
081 refinement ( see Figure 4 ) ( 3 ) . This is not reflected in an improvement of
the fracture toughness in HAZ and CR . However , the SEM analysis of tested
specimens has indicated significant differences in fracture surface roughness ,
crack ...
Page 64
Therefore , many kinds of optical filters in infrared red region were used in this
experiment . Figure 3 shows effect of bandpass filters of molten metal image .
Experimental set up was the same as those for figure 2 . Optical filters were set
on ...
Therefore , many kinds of optical filters in infrared red region were used in this
experiment . Figure 3 shows effect of bandpass filters of molten metal image .
Experimental set up was the same as those for figure 2 . Optical filters were set
on ...
Page 84
000 100 20 40 60 Wire feed speed down [ % ] 80 40 60 Wire foed spoed down [
% ] Figure 8 Arc phase ( parameters Figure 7 ) Figure 7 Short circuiting phase ,
specific current , frequency , and short circuiting time ( 1bar , I = cons . )
Movements ...
000 100 20 40 60 Wire feed speed down [ % ] 80 40 60 Wire foed spoed down [
% ] Figure 8 Arc phase ( parameters Figure 7 ) Figure 7 Short circuiting phase ,
specific current , frequency , and short circuiting time ( 1bar , I = cons . )
Movements ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
I | 7 |
OMAE99MAT2041 | 9 |
Copyright | |
29 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applications approach ASME assessment axial backing base behavior bending brace Charpy compared components composite condition Conference Copyright crack critical CTOD curve cyclic defects deposition depth determined developed distribution effect element energy Engineering equations evaluated experimental factors failure fatigue ferrite fiber Figure fire flux fracture toughness function geometry given heat input impact improve increase initiation International joints length limit loading lower material matrix maximum mean measured mechanical method microstructure molten obtained Offshore operation parameters performance phase pipe plate pool prediction present pressure procedure production properties range ratio reduced region requirements residual stress risers short shown shows SINTAP specimens speed standard steel strain strength structures surface Table temperature tensile thickness titanium tube underwater values weld metal wire yield
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 2000 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |