Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 55
Page 148
... Base material ( pipe ) as well as consumable ring consisted of ASTM Grade 29 alloy ( Ti - 6A14V - 0.1Ru ELI ) . Their chemical compositions are given in Table 1 . Table 1 : Chemical analysis of base materials Ti - 6Al - 4V - 0.1Ru ...
... Base material ( pipe ) as well as consumable ring consisted of ASTM Grade 29 alloy ( Ti - 6A14V - 0.1Ru ELI ) . Their chemical compositions are given in Table 1 . Table 1 : Chemical analysis of base materials Ti - 6Al - 4V - 0.1Ru ...
Page 150
... base material should be expected due to the higher yield strength of the consumable ring . Only two specimens tested at 150 ° C and loads at high maximum ( max 730/680 MPa , NF 1.52x10 / 3.88x105 ) failed in the base material . In none ...
... base material should be expected due to the higher yield strength of the consumable ring . Only two specimens tested at 150 ° C and loads at high maximum ( max 730/680 MPa , NF 1.52x10 / 3.88x105 ) failed in the base material . In none ...
Page 289
... base metal , and HAZ toughness . It mainly consist of control of amount of Cu , Ni , Nb in order to control the HAZ microstructure and improve strength of base metal . Addition of small amount of Nb content is also conducted to suppress ...
... base metal , and HAZ toughness . It mainly consist of control of amount of Cu , Ni , Nb in order to control the HAZ microstructure and improve strength of base metal . Addition of small amount of Nb content is also conducted to suppress ...
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
OMAE99MAT2041 | 9 |
Development of the SINTAP Failure Assessment Diagrams for Compatibility With | 19 |
Copyright | |
28 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applications approach ASME assessment base behavior bending CGHAZ Charpy compared component composite condition Conference Copyright crack critical CTOD curve defects deposition depth determined developed distribution dynamic effect element energy Engineering equations equivalent evaluated factors failure fatigue ferrite Figure fire fracture toughness function geometry given hardness heat input impact important improve increase initiation International joints length limit loading lower material matrix maximum mean measured mechanical method microstructure molten observed obtained offshore operating parameters performance phase pipe plate prediction present pressure procedure production properties protection range ratio reduced region requirements residual stress respectively risers safety ship shown shows specimens standards steel strain strength structures surface Table temperature tensile thickness values weld metal welded joints wire yield