Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 47
Page 35
butt welds in plates : long longitudinal surface defects , short longitudinal surface
defects , transverse through thickness defects . the weld metal were 511 MPa and
591 MPa . The pipe had a diameter of 1000 mm and a wall thickness of 30 mm ...
butt welds in plates : long longitudinal surface defects , short longitudinal surface
defects , transverse through thickness defects . the weld metal were 511 MPa and
591 MPa . The pipe had a diameter of 1000 mm and a wall thickness of 30 mm ...
Page 36
Stress intensity factors at short surface defects at the toes of T - butt welds were
calculated by resolving them into membrane and bending components and using
the Newman and Raju equations ( 11 ) . These were then compared with the ...
Stress intensity factors at short surface defects at the toes of T - butt welds were
calculated by resolving them into membrane and bending components and using
the Newman and Raju equations ( 11 ) . These were then compared with the ...
Page 117
The welds contain artificially induced internal weld defects significantly larger
than those typically accepted in tendon fabrication . Girth welded pipes , left in the
as - welded condition , typically exhibit fatigue cracking at the weld toes when ...
The welds contain artificially induced internal weld defects significantly larger
than those typically accepted in tendon fabrication . Girth welded pipes , left in the
as - welded condition , typically exhibit fatigue cracking at the weld toes when ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
I | 7 |
OMAE99MAT2041 | 9 |
Copyright | |
29 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applications approach ASME assessment axial backing base behavior bending brace Charpy compared components composite condition Conference Copyright crack critical CTOD curve cyclic defects deposition depth determined developed distribution effect element energy Engineering equations evaluated experimental factors failure fatigue ferrite fiber Figure fire flux fracture toughness function geometry given heat input impact improve increase initiation International joints length limit loading lower material matrix maximum mean measured mechanical method microstructure molten obtained Offshore operation parameters performance phase pipe plate pool prediction present pressure procedure production properties range ratio reduced region requirements residual stress risers short shown shows SINTAP specimens speed standard steel strain strength structures surface Table temperature tensile thickness titanium tube underwater values weld metal wire yield
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 2000 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |