Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 11
Page 41
The process is characterised by its ability to give high deposition rates in
combination with a high integrity weld deposit . Several methods have been
developed to increase the deposition rate of the process and these include
multiple wire ...
The process is characterised by its ability to give high deposition rates in
combination with a high integrity weld deposit . Several methods have been
developed to increase the deposition rate of the process and these include
multiple wire ...
Page 42
5kg / hr for tandem wire welding resulting in increases in deposition rate of 70 %
and 50 % respectively . The use of hot wire additions to the rear of the weld pool
has been used , however , repeated process problems with this technique ( 2 ) ...
5kg / hr for tandem wire welding resulting in increases in deposition rate of 70 %
and 50 % respectively . The use of hot wire additions to the rear of the weld pool
has been used , however , repeated process problems with this technique ( 2 ) ...
Page 43
SINGLE WIRE SAW - EFFECT OF WIRE DIAMETER Typical deposition rates for
wire diameter versus welding current show increased deposition rates at smaller
wire diameters ( Fig . 3 ) . These values are widely accepted by fabricators and ...
SINGLE WIRE SAW - EFFECT OF WIRE DIAMETER Typical deposition rates for
wire diameter versus welding current show increased deposition rates at smaller
wire diameters ( Fig . 3 ) . These values are widely accepted by fabricators and ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
I | 7 |
OMAE99MAT2041 | 9 |
Copyright | |
29 other sections not shown
Other editions - View all
Common terms and phrases
addition analysis applications approach ASME assessment axial backing base behavior bending brace Charpy compared components composite condition Conference Copyright crack critical CTOD curve cyclic defects deposition depth determined developed distribution effect element energy Engineering equations evaluated experimental factors failure fatigue ferrite fiber Figure fire flux fracture toughness function geometry given heat input impact improve increase initiation International joints length limit loading lower material matrix maximum mean measured mechanical method microstructure molten obtained Offshore operation parameters performance phase pipe plate pool prediction present pressure procedure production properties range ratio reduced region requirements residual stress risers short shown shows SINTAP specimens speed standard steel strain strength structures surface Table temperature tensile thickness titanium tube underwater values weld metal wire yield
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 2000 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |