Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 19
Page 93
... hardness distribution for welded metal by copper backing . The hardnesses were between 240-270 HV for HAZ and weld metal . The hardness was slightly high in the case of sliding backing compared to the fixed backing case . The hardness ...
... hardness distribution for welded metal by copper backing . The hardnesses were between 240-270 HV for HAZ and weld metal . The hardness was slightly high in the case of sliding backing compared to the fixed backing case . The hardness ...
Page 283
... hardness of weld metals of a low carbon 13 % Cr steel were investigated . The welding consumable used was matching type and for duplex stainless steels . GTAW , GMAW and SAW were employed as the welding methods to alter the chemistry ...
... hardness of weld metals of a low carbon 13 % Cr steel were investigated . The welding consumable used was matching type and for duplex stainless steels . GTAW , GMAW and SAW were employed as the welding methods to alter the chemistry ...
Page 286
... hardness can not be observed . The hardness lies around Hv 280 and this hardness is suitable for API grade up to X80 . Improvement of SAW Weld metal Toughness Fig . 9 and Table 5 show microstructure and chemical composition of the weld ...
... hardness can not be observed . The hardness lies around Hv 280 and this hardness is suitable for API grade up to X80 . Improvement of SAW Weld metal Toughness Fig . 9 and Table 5 show microstructure and chemical composition of the weld ...
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
OMAE99MAT2041 | 9 |
Development of the SINTAP Failure Assessment Diagrams for Compatibility With | 19 |
Copyright | |
28 other sections not shown
Other editions - View all
Common terms and phrases
absorbed energy analysis Arctic Engineering July ASME assessment austenite base metal behavior bending brace CGHAZ Charpy impact Charpy impact test chord component composite material Conference On Offshore copper backing Copyright CTOD value curve cyclic defects developed dynamic effect Engineering July 11-16 equations equivalent CTOD evaluated fatigue tests ferrite fiber fire flux fracture toughness geometry GMAW GTAW HAZ toughness heat input increase intumescents iteration matrix maximum mechanical properties Mechanics and Arctic method microstructure notch obtained Offshore Mechanics offshore structures parameters passive fire protection porosity procedure Proceedings of OMAE99 PWHT ratio requirements residual stress risers S-N curve SCFEX shielding gas short circuiting SINTAP specimens standards steel plates strain stress intensity submerged arc welding surface Table temperature test results thickness titanium underwater welding Weibull stress weld metal weld pool weld toe welded joints wet welding wide plate wire yield strength