Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 48
Page 33
High heat input) For ferritic pipe butt joints for which the heat input per unit
thickness exceeds eOJ/mm2, a'T lay = -cos (»: / T) (11) where z is measured from
the outer surface. The residual stress at the outer surface of the pipe is always in
...
High heat input) For ferritic pipe butt joints for which the heat input per unit
thickness exceeds eOJ/mm2, a'T lay = -cos (»: / T) (11) where z is measured from
the outer surface. The residual stress at the outer surface of the pipe is always in
...
Page 138
Weld toe angle and weld toe radius, as defined in Figure 2, were measured on
cross-sections from the weld joints taken from between the fatigue tested
specimens. Weld start/stop positions were not selected for analysis, since they
were ...
Weld toe angle and weld toe radius, as defined in Figure 2, were measured on
cross-sections from the weld joints taken from between the fatigue tested
specimens. Weld start/stop positions were not selected for analysis, since they
were ...
Page 162
Strains were measured in the static tests prior to fatigue loading. Loading was
applied by a computer controlled servohydraulic actuator system operated in
load control. EXPERIMENTAL PROCEDURE Static Tests Prior to fatigue testing,
all the ...
Strains were measured in the static tests prior to fatigue loading. Loading was
applied by a computer controlled servohydraulic actuator system operated in
load control. EXPERIMENTAL PROCEDURE Static Tests Prior to fatigue testing,
all the ...
What people are saying - Write a review
We haven't found any reviews in the usual places.
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
OMAE99MAT2041 | 9 |
OMAE99MAT2042 | 19 |
Copyright | |
30 other sections not shown
Other editions - View all
Common terms and phrases
analysis Arctic Engineering July as-welded ASME assessment austenite base metal behavior bending brace CGHAZ Charpy impact Charpy impact test chord component composite material Conference On Offshore copper backing Copyright CTOD values curve cyclic defects developed distribution dynamic effect electrode element equations equivalent CTOD evaluated fatigue tests ferrite fiber fire flux fracture toughness geometry girth welded pipes GTAW HAZ toughness heat input increase International Conference intumescents iteration matrix mechanical properties Mechanics and Arctic method microstructure molten metal molten pool obtained Offshore Mechanics offshore structures parameters passive fire protection porosity PWHT ratio requirements residual stress risers S-N curve shielding gas short circuiting shown in Figure shows SINTAP specimens standards steel plates strain submerged arc welding surface Table temperature test results thickness titanium tube underwater welding weld metal weld pool weld toe welded joints welding conditions wet welding wire yield strength
Bibliographic information
| Title | Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3 |
| Contributors | OMAE Conference Committee, American Society of Mechanical Engineers. Offshore Mechanics and Arctic Engineering Division, American Society of Mechanical Engineers |
| Publisher | American Society of Mechanical Engineers, 2000 |
| Original from | the University of Michigan |
| Digitized | 3 Dec 2007 |
| Export Citation | BiBTeX EndNote RefMan |