Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 46
Page 138
... measured on cross - sections from the weld joints taken from between the fatigue tested specimens . Weld start / stop positions were not selected for analysis , since they were unrepresentative of the weld toes within the fatigue test ...
... measured on cross - sections from the weld joints taken from between the fatigue tested specimens . Weld start / stop positions were not selected for analysis , since they were unrepresentative of the weld toes within the fatigue test ...
Page 164
... measured SCF . On the basis of measured hot spot stress the fatigue strength of the CRHS joints was in reasonably good correspondence with the current fatigue design guidance for tubular joints . Due to the combination of a simple weld ...
... measured SCF . On the basis of measured hot spot stress the fatigue strength of the CRHS joints was in reasonably good correspondence with the current fatigue design guidance for tubular joints . Due to the combination of a simple weld ...
Page 215
Table 1 Measured peak forces during impacts with 3.65 - m - size , 50 - mm - thick floes . Table 3. Measured peak forces during impacts with 3.05 - m- size , 152 - mm - thick floes . Test Number of floes impacted 2 2 Peak Force ( kN ) ...
Table 1 Measured peak forces during impacts with 3.65 - m - size , 50 - mm - thick floes . Table 3. Measured peak forces during impacts with 3.05 - m- size , 152 - mm - thick floes . Test Number of floes impacted 2 2 Peak Force ( kN ) ...
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
OMAE99MAT2041 | 9 |
Development of the SINTAP Failure Assessment Diagrams for Compatibility With | 19 |
Copyright | |
28 other sections not shown
Other editions - View all
Common terms and phrases
absorbed energy analysis Arctic Engineering July ASME assessment austenite base metal behavior bending brace CGHAZ Charpy impact Charpy impact test chord component composite material Conference On Offshore copper backing Copyright CTOD value curve cyclic defects developed dynamic effect Engineering July 11-16 equations equivalent CTOD evaluated fatigue tests ferrite fiber fire flux fracture toughness geometry GMAW GTAW HAZ toughness heat input increase intumescents iteration matrix maximum mechanical properties Mechanics and Arctic method microstructure notch obtained Offshore Mechanics offshore structures parameters passive fire protection porosity procedure Proceedings of OMAE99 PWHT ratio requirements residual stress risers S-N curve SCFEX shielding gas short circuiting SINTAP specimens standards steel plates strain stress intensity submerged arc welding surface Table temperature test results thickness titanium underwater welding Weibull stress weld metal weld pool weld toe welded joints wet welding wide plate wire yield strength