Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 77
Page 91
... shown in figure 4 ( a ) and ( b ) . When the miss - alignment became 2mm , small porosity was sometimes appeared near opening side as shown in figure 4 ( c ) . The prototype copper backing was used in this case . This porosity was not ...
... shown in figure 4 ( a ) and ( b ) . When the miss - alignment became 2mm , small porosity was sometimes appeared near opening side as shown in figure 4 ( c ) . The prototype copper backing was used in this case . This porosity was not ...
Page 106
... shown in Figure 7. Acicular ferrite is preferred over the PF and FS microstructures due to its resistance to cleavage fracture . Figure 8 shows the difference in microstructure produced with the addition of titanium and boron at 140 ft ...
... shown in Figure 7. Acicular ferrite is preferred over the PF and FS microstructures due to its resistance to cleavage fracture . Figure 8 shows the difference in microstructure produced with the addition of titanium and boron at 140 ft ...
Page 197
... given here , with high k value is suitable . As shown in Figure 3 , k = 1.3 gives the best fit for Awerbuch and Hahn's data for the carbon / epoxy composite fatigue with : max ATLT + kσ = 43 N 0.0624 ( 4 ) Another critical issue in ...
... given here , with high k value is suitable . As shown in Figure 3 , k = 1.3 gives the best fit for Awerbuch and Hahn's data for the carbon / epoxy composite fatigue with : max ATLT + kσ = 43 N 0.0624 ( 4 ) Another critical issue in ...
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
OMAE99MAT2041 | 9 |
Development of the SINTAP Failure Assessment Diagrams for Compatibility With | 19 |
Copyright | |
28 other sections not shown
Other editions - View all
Common terms and phrases
absorbed energy analysis Arctic Engineering July ASME assessment austenite base metal behavior bending brace CGHAZ Charpy impact Charpy impact test chord component composite material Conference On Offshore copper backing Copyright CTOD value curve cyclic defects developed dynamic effect Engineering July 11-16 equations equivalent CTOD evaluated fatigue tests ferrite fiber fire flux fracture toughness geometry GMAW GTAW HAZ toughness heat input increase intumescents iteration matrix maximum mechanical properties Mechanics and Arctic method microstructure notch obtained Offshore Mechanics offshore structures parameters passive fire protection porosity procedure Proceedings of OMAE99 PWHT ratio requirements residual stress risers S-N curve SCFEX shielding gas short circuiting SINTAP specimens standards steel plates strain stress intensity submerged arc welding surface Table temperature test results thickness titanium underwater welding Weibull stress weld metal weld pool weld toe welded joints wet welding wide plate wire yield strength