Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 18, Part 3American Society of Mechanical Engineers, 2000 - Arctic regions |
From inside the book
Results 1-3 of 62
Page 32
... joints 25-100 Tubular & pipe 22-50 1.4 0.6-2.0 376-421 360-490 to plate joints Repair welds 75-152 1.2-1.6 500 - 590 Table 1 Overview of residual stress data experimental work on thick , welded A533B steel plates . In addition , a study ...
... joints 25-100 Tubular & pipe 22-50 1.4 0.6-2.0 376-421 360-490 to plate joints Repair welds 75-152 1.2-1.6 500 - 590 Table 1 Overview of residual stress data experimental work on thick , welded A533B steel plates . In addition , a study ...
Page 55
... joints in titanium risers is one important issue concerning the structural integrity of such systems . Fracture toughness data from RFW joints were generated from three point bending specimens extracted from welded pipes of Ti - 6Al ...
... joints in titanium risers is one important issue concerning the structural integrity of such systems . Fracture toughness data from RFW joints were generated from three point bending specimens extracted from welded pipes of Ti - 6Al ...
Page 134
... welded pipes is acceptable , providing that the state of the stress , i.e. the residual stress , and the defect size ... joints to predict the performance of girth welded pipes , providing the data are properly analyzed . RECOMMENDED S ...
... welded pipes is acceptable , providing that the state of the stress , i.e. the residual stress , and the defect size ... joints to predict the performance of girth welded pipes , providing the data are properly analyzed . RECOMMENDED S ...
Contents
STRUCTURAL INTEGRITY PROCEDURES FOR EUROPE SINTAP | 1 |
OMAE99MAT2041 | 9 |
Development of the SINTAP Failure Assessment Diagrams for Compatibility With | 19 |
Copyright | |
28 other sections not shown
Other editions - View all
Common terms and phrases
absorbed energy analysis Arctic Engineering July ASME assessment austenite base metal behavior bending brace CGHAZ Charpy impact Charpy impact test chord component composite material Conference On Offshore copper backing Copyright CTOD value curve cyclic defects developed dynamic effect Engineering July 11-16 equations equivalent CTOD evaluated fatigue tests ferrite fiber fire flux fracture toughness geometry GMAW GTAW HAZ toughness heat input increase intumescents iteration matrix maximum mechanical properties Mechanics and Arctic method microstructure notch obtained Offshore Mechanics offshore structures parameters passive fire protection porosity procedure Proceedings of OMAE99 PWHT ratio requirements residual stress risers S-N curve SCFEX shielding gas short circuiting SINTAP specimens standards steel plates strain stress intensity submerged arc welding surface Table temperature test results thickness titanium underwater welding Weibull stress weld metal weld pool weld toe welded joints wet welding wide plate wire yield strength