Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 9American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 76
Page 272
... calculated according to the procedure ( eq . 3 ) described above . If one uses the same nominal stress range AS , calculated as the stress range in the pipe due to the nominal load only , the dynamic stress concentration factors calculated ...
... calculated according to the procedure ( eq . 3 ) described above . If one uses the same nominal stress range AS , calculated as the stress range in the pipe due to the nominal load only , the dynamic stress concentration factors calculated ...
Page 357
... CALCULATION , COMPARISON AND DISCUSSION Using the calculation method , the fatigue lives of three T - tubular joint models are computed and the calculated results are compared with experimen- tal data . The crack growth data of model A ...
... CALCULATION , COMPARISON AND DISCUSSION Using the calculation method , the fatigue lives of three T - tubular joint models are computed and the calculated results are compared with experimen- tal data . The crack growth data of model A ...
Page 358
Table 6. Calculation factors 10.8 | 3.07 45 Table 7. Calculation result and experimental data ( × 10 * cycle , mm ) 17016360 M -- Model ; E D -- Experimental data ; CR -- Calculated results ; N .-- Microcrack growth life ; N ...
Table 6. Calculation factors 10.8 | 3.07 45 Table 7. Calculation result and experimental data ( × 10 * cycle , mm ) 17016360 M -- Model ; E D -- Experimental data ; CR -- Calculated results ; N .-- Microcrack growth life ; N ...
Contents
ADVANCED COMPOSITES | 1 |
Probabilistic Aspects of HAZ CTOD Value of Multipass Welded Joint of Steel for Offshore | 5 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
29 other sections not shown
Other editions - View all
Common terms and phrases
analysis applications as-welded ASTM axial load behaviour bending brace calculated chord Composite Materials compressive strength corrosion rate crack growth CTOD cycles damage delamination elastomer Engineering environment epoxy experimental failure fatigue crack fatigue design fatigue strength fatigue tests Figure finite element finite element analysis fracture mechanics fracture toughness geometry increase initial installation interlaminar fracture laminate layers marine matrix maximum mean stress method Mode modulus moisture nodes nominal notch obtained offshore structures optical fiber parameters performance phenolic pipe plate thickness platform pre-load predicted pressure principal stress pultrusion rebar reinforcement resin resistance riser rubber S-N curves sea water seal shear stress shell shown in Fig space frame specimens steel strain stress concentration stress concentration factor stress range surface crack Table techniques tensile strength tension thickness effect thread tube tubular joints values water mixed concrete weight weld toe welded joints yield strength zone