Proceedings of the ... International Conference on Offshore Mechanics and Arctic Engineering, Volume 9American Society of Mechanical Engineers, 1990 - Arctic regions |
From inside the book
Results 1-3 of 65
Page 259
... compared with the histogram given by Denys and Lefevre ( 1989 ) . The yield strengths are measured in plates 25mm to 60mm in thickness . The range of the yield strength is 400 to 480MPa . The scatter is comparable to the scatter in the ...
... compared with the histogram given by Denys and Lefevre ( 1989 ) . The yield strengths are measured in plates 25mm to 60mm in thickness . The range of the yield strength is 400 to 480MPa . The scatter is comparable to the scatter in the ...
Page 314
... Compared to the corresponding simple joints , the load transmission from brace to chord in the ring stiffened joints is more favourable , the bending moment at the hot spot reduces considerably and the membrane stress is more uniform ...
... Compared to the corresponding simple joints , the load transmission from brace to chord in the ring stiffened joints is more favourable , the bending moment at the hot spot reduces considerably and the membrane stress is more uniform ...
Page 332
... compared to simple node geometry . Complex node geometry has an effect on the SCF in the fillet and chord weld area . increase in SCF up to 70 % , compared simple node geometry , was found . An to Loads in the chord may have a ...
... compared to simple node geometry . Complex node geometry has an effect on the SCF in the fillet and chord weld area . increase in SCF up to 70 % , compared simple node geometry , was found . An to Loads in the chord may have a ...
Contents
ADVANCED COMPOSITES | 1 |
Probabilistic Aspects of HAZ CTOD Value of Multipass Welded Joint of Steel for Offshore | 5 |
The Use of GRP Materials in Platform Topsides Construction and the Regulatory Implications | 15 |
35 other sections not shown
Other editions - View all
Common terms and phrases
analysis applications as-welded ASTM axial load behaviour bending brace calculated chord Composite Materials compressive strength corrosion rate crack growth CTOD cycles damage delamination elastomer Engineering environment epoxy experimental failure fatigue crack fatigue design fatigue strength fatigue tests Figure finite element finite element analysis fracture mechanics fracture toughness geometry increase initial installation interlaminar fracture laminate layers marine matrix maximum mean stress method Mode modulus moisture nodes nominal notch obtained offshore structures optical fiber parameters performance phenolic pipe plate thickness platform pre-load predicted pressure principal stress pultrusion rebar reinforcement resin resistance riser rubber S-N curves sea water seal shear stress shell shown in Fig space frame specimens steel strain stress concentration stress concentration factor stress range surface crack Table techniques tensile strength tension thickness effect thread tube tubular joints values water mixed concrete weight weld toe welded joints yield strength zone